PDA

View Full Version : bad object handle


ABC123

Madelene Ferguson Allen
07-25-2000, 10:20 AM
I have put a subform within an invoice form. When I run print preview I get the message "bad object handle". Nowhere (that I can find) in help is this mentioned. What is it and what should I do. Have done this proceedure before, no problem.
Madelene

Melvin Davidson
07-26-2000, 01:50 PM
Madelene,

No guarantee, but try editing the report. From the
menu, select Report, Report Properties, Report and then
check /uncheck Optimize complex reports.

If that doesn't work, try doing a maintenance on the
.set or .dbf that contains the report.

Madelene Ferguson Allen
07-26-2000, 06:52 PM
Thanks for the ideas Melvin .. I am doing this on a form ... not a report. Interestingly enough I tried to print individual form and it worked!! Message only appears when you do print preview.
Madelene