This "bug" was apparently introduced with the 4.5 upgrade, and it concerns report printing.
I'm printing to a form that is 6" x 8.5". The top 3.6" of the page is the page header area. The report is based on a many-to-one set, and it page breaks on a change in the key of the parent DB. Each DB record will fit onto a single page of the report form and reflects data for one of my clients. These are invoices. Hard coded into the report is the printer selection, an Epson 24 pin impact printer.
Page 1 prints correctly. The client header is in the correct place, the client's detail data is in the correct place, and the page break occurs at the correct place. So far so good.
Page 2 header prints correctly, and the client 2 page 2 detail prints correctly, However, there is NO page break at the end of page 2 detail. Instead, the detail for page 3 (client 3) prints immediately after the detail of client 2. At the physical end of the page, there IS a page break and the page header data for client 3 is printed followed by the continuation of the detail data for client 3, and that is immediately followed by whatever data for client 4 fits on that page. At the end of that page is another page break, and the same behavior is repeated.
That behavior continues for the remainder of the report.
No changes were made to the report before or after installation of the 4.5 upgrade. Any suggestions on troubleshooting this (if it's not an A5 bug)?
I'm printing to a form that is 6" x 8.5". The top 3.6" of the page is the page header area. The report is based on a many-to-one set, and it page breaks on a change in the key of the parent DB. Each DB record will fit onto a single page of the report form and reflects data for one of my clients. These are invoices. Hard coded into the report is the printer selection, an Epson 24 pin impact printer.
Page 1 prints correctly. The client header is in the correct place, the client's detail data is in the correct place, and the page break occurs at the correct place. So far so good.
Page 2 header prints correctly, and the client 2 page 2 detail prints correctly, However, there is NO page break at the end of page 2 detail. Instead, the detail for page 3 (client 3) prints immediately after the detail of client 2. At the physical end of the page, there IS a page break and the page header data for client 3 is printed followed by the continuation of the detail data for client 3, and that is immediately followed by whatever data for client 4 fits on that page. At the end of that page is another page break, and the same behavior is repeated.
That behavior continues for the remainder of the report.
No changes were made to the report before or after installation of the 4.5 upgrade. Any suggestions on troubleshooting this (if it's not an A5 bug)?
Comment